top of page
Store your filaments in the right way
3D PRINTING FILAMENT VACUUM PUMP
WHY YOU NEED EURUS
Water molecules in the air will strongly affect 3D printing filament, especially those with severe water absorption. The printing difficulty and printing results of nylon filament left in the air for one day will be extremely different compared to when they were just opened. Even if material like PLA or PLA+, the content of water molecules in the filament will also increase after being left for half month.
Whether you are a 3D printing amateur or a pro, you defently have the filament that have been opened but not used up. Incorrect storage methods will directly cause these filaments lose their original properties. Eurus is able to help you deal with this situation in order to protect your filaments.
Components of EURUS
1.2M POWER CORD
USB POWER INTERFACE
Features of EURUS
Compatible with various 5V power supplies such as mobile phone chargers and power banks
DEDICATED VACCUM BAG
Specially designed vacuum bag and exhaust valve for 3D printing filament spool
EXCELLENT SEALING RESULT
Able to keep the state for more than 1 year after pumping
Input Voltage：DC 5V 0.6A
Product Size：φ34 x 86 mm
Minimum no-load Flow：2.5L/min
Vacuum Bag Material：PA+PE
Vacuum Bag Size：350x380mm
1. PUT THE FILAMENTS IN
2. CONNECT THE POWER SUPPLY
Put the filament into the vacuum bag (Desiccant can be put in at the same time).
Use the bag clip to seal it.
Eurus can be connected to various USB ports with an output voltage of less than 5V,Including: computer, portable battery, mobile phone charger...
3. CONNECT THE VACUUM PORT
Connect the vacuum pump with the threaded port of the vacuum bag. Turn the power on and wait for a few minutes.
4. PUMPING IS COMPLETE
Screw on the lid after pumping.
In order to protect your filament,
EURUS is now available in our official
Subscribe for the latest information!
bottom of page